ingot700x150a

Our Aerosol prodcuts can be applied easily when using the following advices:

 

• Remove dust and loose remains of melt, slag etc. from the surface to be coated.
• Shake can well before use.
• Spray from a distance of 20 cm (8") in order to produce an even coating.
• Best results are achieved by even movements when spraying.
• Apply thin coatings. Thick coatings may may crack upon drying.
• Additional layers may be applied after drying.

 

 


© 2023 Büro für angewandte Mineralogie · Dr. Stephan Rudolph · D-47918 Tönisvorst


These recommendations are believed to be correct. However, no guarantee of their accuracy is given. Therefore, purchasers shall make their own tests to determine suitability for their use. These products are offered for industrial and related uses (e.g. research and development) only. However the user must take the necessary precautions appropriate for products containing chemicals. This description does not imply the absence of any patents, the responsibility whatsoever solely rests with the user.

Application procedures - Boron Nitride

alu-stop.com

The Original